SGP81 - Tromix Bolt Carrier Extension $25 ea.
Bolt Carrier Extension (1.3” length) For use when making 12" and
14" barreled SBS Saigas where the gas system is shortened 2.25
inches. Also used on 19" competition guns to allow them to cycle
very low power ammo or for use with mid-barrel comps. These have
a large diameter flange at the base which keeps the bolt carrier
and bolt held downward during cycling, so the bolt does not ride
up and miss the ejector. Made from 17-4 Stainless.
SGP80 - Tromix Heavy Hitter S-12 Firing Pin with Spring.
$20ea.
SGP74 - Limbsaver Recoil Pad
(For Tromix Buttstock) $60ea.
SGP75 - Do-It-Yourself Trigger Guard Kit -
This bolt-on kit allows you to relocate your
trigger guard forward on your S-12
and also provides a threaded boss to mount your SAW pistol grip.
includes integrated safety stop as well. (Not compatible with
S-12’s equipped with automatic last round bolt hold open
devices)
$45ea.
SGP79 -
Bolt-On Oversize Charging Handle - This bolt-on handle fits
over any AK-47 charging handle, to give you a better grip while
charging your gun. $22ea.
Installation
Instructions-
1. Run the set screw completely through the handle, until it
drops out into the center bore. That will ensure that screw is
not stopping on any foreign debris left over from sand blasting. 2. Clean and degrease both the threads in the handle and the set
screw with contact cleaner and allow to dry completely. 3. Apply red #262 Lock Tight to BOTH the set screw and the
threads in the charging handle.
4. With the bolt carrier installed in the receiver, slide the
Tromix handle over the OEM handle and start the set screw.
Slowly turn the set screw inward as you wiggle the handle in
order to allow the set screw to find the "sweet spot" in the
saddle of the OEM handle.
5. Using a large 4.5" long allen wrench, hoss that screw down
until you think it's about to break. It won't.
Now available
in Smooth finish as well. Shown on right
SGP07- Shark Brake Door Breacher
(Saiga 12ga.) $85
SGP09- Vented OEM Handguard $40
SGP34- Receiver Back Plate $15
SGP35- Fire Control Group $49
SGP44A- Stocks - Ace $65
Out of Stock
A
SGP44B-Stocks - Tromix $85
B
SGP44C- Stocks -
Tromix w/Limbsaver $150
C
SGP45- Trigger Guard $15
SGP51- Galil Charging Handle $45 (Weld Install)
SGP58- XS Sights - Tritium Front, Ghost Ring Rear $120 (must have HK type sights installed)
SGP73- HK Rear Sight Base w/Extended Picatinny Rail
(weld-on) $150
Does not include HK sights.
(All parts are U.S. made except the OEM handguard and HK sights)
MIX HOME
